3Bars Aroma Laser Hair Removal Handpiece Repair Services

This VS-MI-100-3-FL-A is an 808nm diode laser stack, which has 3pcs 100w bars with black side plate. Electrodes are on the back of the stack.
It is used for 808nm diode laser hair removal handpiece repairing and replacement. Exp: Aroma Laser hair removal handpiece
Oriental-laser focused on diode laser bar assembling for more than 16 years and we have seen various alma soprano diode laser stacks.Also we can use the same Jenoptik bar like Alma used to recondition the power the laser soprano power.

Repairing Solution:

Repairing procedure Advantages
>Chioce A: Send the old broken handpiece to our facatory. We will do the process of checking , repairing, cleanning and etc. Then send the fresh new handpiece back to you. >Save Money. Replace the broken diode stack only. Low cost and convenient
>Chioce B: if you have basic assambly capacity, you can send the diode laser stack only to our factory. We remove the old bar and mount the new bar to recover the laser power of the stack. >Long life time. we use diode laser bars from Germany. The newest Ausn mounting technology will be applied when repairing. After repair. The handpiece will be as a new one. life time is much longer than before
>Choice C: Measure your stack and comfrim the water pipe hole and screw hole position. Then press the button below to buy a ready-made stack which is match your old hadnpiece. >All technical support available. We major in diode laser mounting, software, spare parts over 16 years. All the technologies about laser hair removal machine are open to you.

Specification:

Model No. VS-MI-100-3-FL-A
Application laser hair remova Handpiece Repair And Replacement exp: Aroma diode
Operation Mode CW
Power per submounts 100W
Number of submounts in one stack 3bars
Central wavelength at 25℃ 808 ± 5nm
Typical Operation current 85A
Maximum Operating current 100A
Typical Threshold current 15A
Maximum Operating Voltage <6V
Fast Axis Divergence (FWHM) 39º
Slow Axis Divergence (FWHM)
Operation Condition non-condemsing atmosphere, cleaning room
Expected lifetime 10000hours
Typical pitch per bar 1.8mm
Cooling requirement
Flow rate 1L/min +-10%
Water Temperature 25+-3°C
Water Quality Deionized 2-10 µs/cm, mixed bed ion exchanger,particle filter<25µm
cooling system Do not use any material that combination with copper would form galvanic elements

Dimension(dimension is upon 4bars stack)

 

Leave a Reply

Your email address will not be published. Required fields are marked *